خط النشر/الحفر باستخدام الحاسب الآلي

VERNET BEHRINGER HD-SFVO 412-S HBE 320/523 G

HD-SFVO 412-S HBE 320/523 G- YEAR 2019. Marking-drilling-milling-shearing & sawing line

HD-SFVO 412-S DRILLING CAPACITY.
Flat bars: 50x10 to 400x30
Angles: 50x50x5 to 250x250x20
IPN-IPE: 80 to 400
HEA-HEB: 100 to 400
UPN-UPE: 80 to 400
Square and rectangular tubes: 50x50 to 300x300x20

HBE 320/523 G SAWING MACHINE.
Effective cross-section (mm):
90°: 400x300
Bevel cut, left pivot (W x H, mm):
75°: 400x300
60°: 400x300
45°: 330x300
30°: 200x300
Bevel cut, right pivot (W x H, mm):
75°: 400x300
60°: 400x300
45°: 310x300

Power supply:
• Three-phase 400V ± 15 V + ground, 50Hz
• Installed power: 40 kVA

Compressed air:
• Minimum pressure: 6 bar
• Maximum flow rate: 3 Nm³/h

Operating temperatures:
• From 10°C to 40°C

Milling unit specially designed for machining small square or rectangular tubes (slotted holes, shaped cuts, etc.).
With the engraving equipment: ability to engrave letters or numbers for part identification.
Allows, among other things, marking of tubes with sufficient depth to ensure legibility after painting or galvanizing
Secure holding of the bar during milling: the bar is clamped in the movable vice system to ensure proper machining while minimizing vibrations.
Improved positional tolerance of one hole relative to another within a group of holes (within a maximum length of 150 mm)

Additional features
Cycle for centre punching, countersinking, tapping, deburring, and chip breaking
Automatic measurement of tool length (HSS)
Side and centre tool cooling

230-ton shear Feature
Mobile hydraulic shear
Straight cut
Average cutting time: approximately 2 to 2.5 seconds
Capacities:
HEB 140
IPE 300
IPN 280
Angle bars 150x150x18
L 200x100x14
UPE 300
UPN/UPAF 300
Rjdpfx Aoy R Tk Rsaiow
Flat bars 300x20