مقطورة صناعية VAL30 – حمولة صافية 25 طن

Multi-Trans VAL30

Operating conditions:
The industrial trailer is designed for use on level, paved surfaces in internal transport operations.

Multiple trailer operation:
The trailer components are not designed (without a coupling device) for combined operation with multiple trailers.
Hodpsxrtb Nsfx Andep

Payload:
The industrial trailer can carry loads up to a maximum of 25 t at 6 km/h with evenly distributed loading (surface load) between the axles. Point or line loads are only permissible upon notification.

Base frame:
The base frame of the industrial trailer consists of a robust welded construction made of profile steel.

Loading platform:
Dimensions are approx. 6000 x 2400 mm. Loading height approx. 750 mm. The platform is covered with softwood planks and bordered with all-round edge protection.

Steering:
Four-wheel axle pivot steering, drawbar can be raised, detached, and swapped from front to rear. Drawbar eye height at towing vehicle approx. 285 – 775 mm (other heights only possible upon notification), drawbar eye according to DIN 74054, diameter 40 mm, drawbar drop safety device according to UVV.

Chassis:
Both axles of the industrial trailer are steered. Solid elastic rubber tires approx. 559 x 356 mm, wheel hubs with tapered roller bearings and long-life grease lubrication.

Paintwork:
Finish in RAL 5002 ultramarine blue.

Additional equipment:
Two lashing rods made of round steel are welded vertically into the outer side frames on each longitudinal side of the industrial trailer.

Rental or sale EU-wide.

تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.