مركز تشغيل أفقي SH50

MORI SEIKI SH-50

We are offering this used MORI SEIKI SH-50 horizontal machining center, year of manufacture 1996.

Model: SH-50
Serial Number: 450

The machine is still under power and can be made available at short notice.

Gsdpfxoyt Nnpe Ahvstw
• P8 power supply valued at 1500.- was replaced as recently as August 2024
• The spindle was repaired in 2017 and since then has mainly been operated in single-shift mode. As we primarily produce individual parts and small batches, the machine has spent most of its time being set up rather than running

• Machine: Mori Seiki SH-50 milling machine
• Control: Fanuc MSX-516
• Year of manufacture: 1996
• Design: Horizontal milling machine with indexing table
• Tool capacity: 60 (BT40)
• Number of pallets: 2 (500mm x 500mm)
• Travel: X 630mm, Y 600mm, Z 650mm
• Spindle speed: 12,000 rpm
• Chip conveyor

Known defects:
Rapid traverse speed on the X-axis has been reduced by 20% to extend the life of the telescopic covers.
Seal ring on the pallet changer is likely defective, resulting in oil leakage. As a temporary fix, we have installed a ball valve in between; whenever a pallet change is required, the valve is opened. This doesn’t happen very often.

If you have any questions or need further information, please feel free to send us a message or call us.

تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.