منشرة كاملة (ثابتة)

MADREW AE-400

The AE-400 SERVO edger is designed for longitudinal trimming and slitting of side boards fed to the machine at high speeds (100-400m/minute).
The machine works directly with conveyors feeding and receiving boards in automatic mode.
The machine is equipped with a board scanner from above and below.
The maximum instantaneous efficiency of the edger up to 55 boards/min can be obtained by cutting a 2.5 m board to the same width without changing the spacing of the saw blades. Each adjustment of the edger node devices to the width of the board causes a change in performance. The average productivity of the machine, depending on the work configuration, ranges from 35-48 boards/min.
technical dance
No. Parameter Value
1. Saw spindle drive motor power. 55 kW
2. The number of revolutions of the saw spindle. 3550 rpm
3. Diameters of used saws. 400mm
4. Maximum cutting height. 50mm
5. Number of saw blades used. 2 to 3 pcs. (2 floating saws)
6. Minimum board length. 2000mm
7. Maximum raw material length. 6200mm
8. Maximum number of boards after cutting 1 board: 2 pcs.
9. Feed: 100- 400m/min

Cutting for 1 board - with two saws (2 floating saws):
1. Minimum saw spacing (board width after cutting) 75 mm
2. Maximum spacing of extreme saw blades (board width after cutting) 300 mm

Cutting into 2 boards - with three saws (2 floating saws),
1. Spacing the saws on the fixed coupler
(board width after cutting) 50-100mm
2. Spacing between floating saws
(board width after cutting) 50-100mm
Csdpfx Ajnygvrsm Rerh
3. Cutting into 2 boards minimum 2 x 50mm
4. Cutting into 2 boards maximum 2 x 100mm

Other machine configurations are possible on request.
We also produce other sawmill lines: log sorting plants, board sorting plants, board stackers, conveyors.