Based on proven HANGLER welded construction using high-quality steel, with forward-tapered, welded longitudinal beams. Frame neck with double center web. Longitudinal beams feature punched Z-profile cross members with welded special side frames. Interchangeable 2" kingpin, with a frontward-sloped grinding plate made of high-quality steel sheet. 18 pairs of stake pockets recessed into the outer frame, each with a capacity of 2.5 tons, 8 pairs of folding stake pockets recessed into the outer frame, each with a capacity of 5 tons, total of 24 tons. 2-speed support winch, single-side operation, with a straight lower part, 2 support wedges with holders, aluminum side impact protection, plastic fenders in front of and behind each axle, with anti-splash flaps behind each axle, underrun protection at the rear, splash flaps at the rear across the entire width, coil trough approximately 8,000 mm long with a cover, approximately 40 mm, divided by angled loading beams. Bracing bushings and supports suitable for FR 80/80/4, fully hot-dip galvanized. Inserted bracing 80/80 including lower reinforcement, hydraulic angled loading system with 4 cross beams: hydraulic supply via tractor unit using a 2-line pump system (supply and return) with a 2-way quick-release coupling. Angled loading beams with integrated extension part that can be locked in height. Hydraulic cylinders are multi-stage, with universal joint suspension on each beam. Includes supports - adjustable - with bolt lock. Cylinder passages with strip brush seals on both sides to protect against weather and to clean the piston rods. 5-way control valve to operate the angled loading system and for the folding mechanism. Sliding tarp system, including tarp rail cover. 1 set of coil support bracket with height-adjustable support bolts for different coil diameters, including storage. 1 piece of stop protection for angled sheet - for protection towards the front, BPW or SAF disc brake axles, depending on the manufacturer's choice, axle spacing offset 1310/1450 mm, air suspension, 2-line compressed air brake system, aluminum air reservoir, spring parking brake, axle load recognition via EBS-CAN bus signal, for display on the driver's cab, the truck must be pre-equipped accordingly, "TPMS" tire pressure monitoring system according to ECE R 141, display on the towing vehicle via EBS, 435/50 R 19.5", manufacturer's choice, 24 volts, multi-chamber lights, yellow LED lighting on the side, yellow LED lighting on the side linked with the turn signal "flashing side marker lights", 2 x 7-pole and 1 x 15-pole fail-safe sockets at the front, additional 7-pole socket (according to ISO 1724) in the underrun protection at the rear, pair of warning signs with double LED lighting and extendable to 3,000 mm, removable with connector, LED beacon with holder, switched on via parking lights, plywood panels approximately 30 mm thick, flush-mounted with the side frame! Front panel made of aluminum hollow profiles, fixed, fixed height approximately 2,400 mm above, with wooden slats. Inside reinforced with 3 mm aluminum sheet approximately 630 mm high from the floor as a plinth scuff protection. 2 pieces of permanently installed front VOLUME corner posts, approximately 2,400 mm high, 3 pairs of Kinnegrip center posts approximately 600 mm high with Kinnetop at approximately 2,000 mm, 1 pair of plug-in rear corner posts including reinforcement inside up to the 1st slat row, aluminum hollow profile, approximately 600 mm high,
Duedpfxji Riw He Afweu
تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.
