مقطورة نصف قلابة

Fliegl DHKA 390 - 50 m³

Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

Further Information
Chassis, Semi-Trailer, Tipper
Fine-grained steel welded construction, in basic lightweight design, turntable with interchangeable 2 kingpin
Curved front end, patented
24 tons, 2-speed landing gear, single-sided operation, with straight lower part, without stroke compensation
2 support wedges with holder
Underrun protection, foldable
Half-shell fenders
Integrated fender holder, surface designed to repel stones
With anti-splash flaps, only on the last axle
1 tarpaulin rod with bracket
2 towing hooks at the rear
Axles + Suspension
BPW disc brake axles with 430 mm disc diameter
Giodji Ri Ihspfx Aa Tsw
Axle/chassis laser-aligned to reduce tire wear and fuel consumption
Air suspension
1st axle, automatic lift axle, including forced lowering and starting aid
Hot-dip galvanized lift axle mechanism, 10-year warranty against rust-through
Braking System
2-line compressed air braking system, color-coded lines for easy servicing
Spring brake parking brake
2 tamper-proof coupling heads at the front, without connection line
EBS, Electronic Braking System with EBS socket at the front, without connection cable
Note: The trailer may only be pulled by tractor units that guarantee the effectiveness of the ABS!
With lifting and lowering valve
Vehicle – Driving Stability System
Wheels and Tires
385/65 R22.5, manufacturer’s choice
Steel rims, factory silver
"TPMS" Tire Pressure Monitoring System according to ECE R 141, display via the tractor unit’s display, via EBS, without installation in the truck (this must be available in the truck. Only on base tires).
Electrical System
24 Volt, multi-chamber lights, yellow LED lighting on the sides
Yellow LED lighting on the sides linked to the turn signal "flashing side lights"
2 white position lights at the front
2 white/red outline lights at the rear
2 x 7-pin tamper-proof sockets at the front, without connection cable
Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard-chromed, with HDK screw sleeve, fixed part, NW 48 mm (without hose connection)
Operated hydraulically via truck auxiliary drive
Tipping Body
Aluminum box tipper body made of high-quality, abrasion-resistant material, front wall 5 mm thick, with outer wall made of 30 mm hollow chamber profiles, neatly welded, with top edge profile that prevents material from spilling out. Inside with access ladder on the front wall (not in connection with Cramaro).
Shovel and broom holder on the outside of the front wall.
Greenline – tapered and aerodynamic tipper body design
Membrane – rear wall
Rear wall with double-joint hinge, mounted to allow movement, with 2-part door division 1/2 to 1/2, at the top with a pivoting gantry, with one grain slide per door.
Rear wall with rubber seal. Note! Heat resistant up to max. 170°C!
Floor consistently 6 mm thick
Standing platform with access ladder, connection plate for air/electrical and brake with large clearance for best possible operation.
Roller cover, single-sided for depositing on the right-hand side, with central locking on the left-hand side
Approval Country/Signage
Germany
Type approval according to EC 2007/46
24/7 service hotline
Prepared for single-row license plate holder
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Painting
Frame DB 7350 Novagra

تمت ترجمة الإعلان تلقائيًا. قد تحدث أخطاء في الترجمة.